Forum Replies Created

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • in reply to: Cannot use Screen builder app #3672
    shuave
    Participant

    ZeRider,

    Do you know how I can send you a video (263 Mb) with the set up
    and responses from HTBasic?
    Thanks

    in reply to: Cannot use Screen builder app #3668
    shuave
    Participant

    Good Morning ZeRider,
    I’m attaching a video for you to see the procedure/loading and error.
    Please advise with your vast knowledge.

    By the way, how can I attached a video?
    Thanks

    in reply to: Cannot use Screen builder app #3667
    shuave
    Participant

    Good Morning ZeRider,
    I’m attaching a video for you to see the procedure/loading and error.
    Please advise with your vast knowledge.

    By the way, how can I attached a video for you to see?

    in reply to: Cannot use Screen builder app #3548
    shuave
    Participant

    Hi ZeRider

    It didn’t work and I’m getting frustrated.
    Sometimes I believe that the COM card for the Analyzer is disconnected
    from inside.
    I found some example code on the Agilent CD’s and tried to load it but
    the same error 163 ,Any other ideas

    Shuave

    in reply to: Cannot use Screen builder app #3541
    shuave
    Participant

    ZeRider,

    Still the same. Does my Analyzer needs to be address as any number in particular?
    I run the connection expert and it said the analyzer is connected with visa gpib1::17::instr
    but the code is assigning as ASSIGN@agt4396 TO 800″, is it ok?
    p/s: the analyzer has two addresses : one for the controller and other for the analyzer itself
    so, what should I used for the controller address?

    Thanks again

    in reply to: Cannot use Screen builder app #3539
    shuave
    Participant

    Hello Community
    I have Loaded every one of the GPIB (HPIB) drivers (one at the time) from the AUTOST file and then open the program and I got “error 163 in 70 interface not present”.
    I’m using a HTBasic v10 for Windows (XP) and a Keysight 82357B USB/GPIB interface adapter to connect to a Spectrum Analyzer. Line 70 is ” ASSIGN@agt4396 TO 800″
    If I leave the AUTOST file unchanged only with:
    COM /Autost/Drivers_loaded
    INTEGER Altf4,Fixcurse,Winpal
    IF NOT Drivers loaded THEN
    Drivers_loaded=1
    END IF
    END
    and then open my program, I will get the same error!
    Anyone knows what I’m doing wrong?
    Thanks a lot for any help

    in reply to: TAMS 60488 card – anyone who has the Windows driver? #3474
    shuave
    Participant

    I also need one for my windows XP.

    Thanks

Viewing 7 posts - 1 through 7 (of 7 total)