Thanks Pat,
We had been using the GPIBNI driver loaded thru device setup.
Some more background:
NiMAX works find and other code platforms successfully use this same hardware on a daily basis.
Previously this basic code had run on an bus-based GPIB card, so the usb-gpib-hs is what changed.
The entire setup is rather dated, running under win 7.
Thanks for the pointer – I installed the 2021 trial demo.
The Device Driver Selection screen identifies the devices on the GPIB bus using the VISA driver and lists them as “verified” (good!).
However, when I select any of these and click “add selected device” I get an “Unable to add Driver” error. (presumably bad)
Is there a missing step here ? not much in the manual on this
Just for info the 2021 trial demo still locks up GPIBNI when I attempt to run our code with that driver loaded !
Thanks,
Matt
