[Troy Pulk]

Thanks for your help Ralph,

I found the problem, the printer port settings got changed and the pooling setting was unchecked.

So, I checked the pooling box and added LPT1 with my printer on it and now the HTBasic printing program works as it did before.

Thanks for helping me.

Good day to you.

[Troy Pulk]

Thanks,

There is nothing in the network after clicking the button.

Also, my code says the ICS is 26 but when I try to set up a new printer or modify this one there is no 26 it goes from 25 to 27.
The set up uses 10 automatically but there is no 10 in the code.

If I change all the 26’s to 10 it only prints one line of letters and numbers.

Also, CONTROL 10,102;1 does not work. I’ve tried different ones like 26,111;1 10,111;1 26,102;1 to no avail.

It also says “sending graphics to HPGL color printer” then it times out.

Can you look at my code above and see if there is another way to writie it?

Since 26 is not working is there a way to see which ICS is working?

Thanks for our help

[Troy Pulk]

Thanks again,

I’ll check that out right away.

[Troy Pulk]

Thanks Ralph,

It’s probably not in the permissions because we have full system wide admin rights with one PW and there are only two accounts Admin and xadmin.

I’ll still check though.

The file goes into the print spooler then gets copied into 00Printed, HTBasic uses Printshop Pro 7 to create the file and sends it to the printer.

How do I check to see if HTBasic even sees the printer on the network?

Thanks

[Author]

Posts